How to Use a Gasoline Pole Saw? Posted by : admin / Posted on : Aug 26,2022

When you're looking to buy a gasoline pole saw, there are a few factors to keep in mind. These factors include starting procedure, Chain tension, Weight, and Power.

Chain tension
Chain tension is one of the most important things to pay attention to when using a gasoline pole saw. It should be loose but not so loose that it can't pull out of the bar.

To adjust the chain tension on a gasoline pole saw, you need to unlock the guide bar and unlock the side panel. This will let you see the tensioning screw, which is located on the side of the guide bars. Tightening the screw will tighten the chain, and loosening it will loosen it.

Weight
The weight of a gas-powered pole saw is an important factor to consider. Gas pole saws typically have larger engines and heavier weight, which adds to their cost. Gas pole saws typically weigh anywhere from 20 to 25 pounds. However, electric pole saws are much lighter, and cordless models are available. Since they do not require batteries or battery technology, they are lighter than gasoline-powered pole saws.

Although gas-powered pole saws are heavier, they are more balanced than their battery-powered counterparts, making them easier to control. While using the gas-powered pole saw, the user should always maintain a proper stance, and try to avoid swaying backwards. This helps maintain a good balance, and is essential when pruning branches and trees. The ideal cutting position is the 'V' position, which is best for cutting trees and branches with a diameter of at least 4 inches. It is important to use quality oil and non-alcoholic gas, as well.

Starting procedure
The starting procedure for a gasoline pole saw is similar to that of a chainsaw. First, you must pull the start/choke control to the ON position. After that, you need to prime the primer bulb and decompress the air purge valve. Then, grasp the front and rear handles using your left hand and right foot. Holding the saw in a stable position, slowly pull the starting handle until the engine starts. Once the engine starts, squeeze the throttle to release the high idle. To stop the saw, turn off the ignition switch.

A clogged fuel filter can also cause a gas pole saw to not start. If the fuel filter is clogged, you need to drain and replace it. Another problem may be a clogged air filter, which can prevent the engine from starting. A clogged air filter will need to be replaced to fix the problem.

Power
A gasoline pole saw is a great choice if you want to get the job done quickly. It can cut up to 16-inch logs and can reach 7-feet high. Gasoline-powered pole saws are also light in weight and have a gas tank that can last for hours. Some models even come with a harness to reduce user fatigue.

Gasoline pole saws feature a 2-cycle engine, also called a 2-stroke. This engine takes two piston strokes to complete a combustion cycle. A 4-cycle engine, on the other hand, uses three or four piston strokes to complete the combustion cycle. This type of engine is normal for gardening tools.